Register
A fuel transfer system shall be designed and installed so that only a pre-set quantity can be transferred, at one time, to the available storage capacity of the receiving tank. The quantity is what percentage
194k views
4 votes
A fuel transfer system shall be designed and installed so that only a pre-set quantity can be transferred, at one time, to the available storage capacity of the receiving tank. The quantity is what percentage of the receiving tank?

User Abdullah Ansari
by
7.5k points

1 Answer

7 votes

Final answer:

The subject of this question is Engineering, and the students are exploring the design and installation of a fuel transfer system that limits the quantity of fuel transferred to a receiving tank.

Step-by-step explanation:

The subject of this question is Engineering. The students are exploring the design and installation of a fuel transfer system that limits the quantity of fuel transferred to a receiving tank. This involves understanding the capacity of the receiving tank and determining the percentage of this capacity that can be transferred at one time.

User Place
by
8.0k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!