Register
Thermo gel, what psi should be delivered to the nozzle
162k views
0 votes
Thermo gel, what psi should be delivered to the nozzle

User Philippe Plantier
by
8.2k points

1 Answer

4 votes

Final answer:

The nozzle pressure for a thermo gel system should be very close to atmospheric pressure, as the water exits into the atmosphere without changes in its conditions. This is because the given pressure is a gauge pressure.

Step-by-step explanation:

The nozzle pressure for a thermo gel system should be very close to atmospheric pressure, as the water exits into the atmosphere without changes in its conditions. This is because the given pressure is a gauge pressure. A gauge pressure measures the pressure relative to atmospheric pressure.

User Ilkkachu
by
8.3k points
← Prev Question Next Question →

Related questions

User Bazzel
asked Jul 17, 2024 133k views
Thermo gel, how many psi friction loss is there per 100' of 1" hose
Bazzel asked Jul 17, 2024
by Bazzel
7.3k points
1 answer
5 votes
133k views
User Nvogel
asked Sep 14, 2024 65.4k views
Thermo gel, how many psi friction loss is added for the eductor
Nvogel asked Sep 14, 2024
by Nvogel
7.5k points
1 answer
2 votes
65.4k views
User Pkoch
asked Nov 1, 2024 229k views
When the possibility of brush fires increases, how much thermo gel must be carried
Pkoch asked Nov 1, 2024
by Pkoch
8.6k points
1 answer
3 votes
229k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!