Register
The Bottom chords of trusses were cut to fit other construction. What is the recommendation?
227k views
1 vote
The Bottom chords of trusses were cut to fit other construction. What is the recommendation?

User Trkoch
by
8.2k points

1 Answer

1 vote

Final answer:

If the bottom chords of trusses were cut to fit other construction, it is recommended to consult a structural engineer or an expert in truss design.

Step-by-step explanation:

If the bottom chords of trusses were cut to fit other construction, it is recommended to consult a structural engineer or an expert in truss design. The bottom chords of trusses play a crucial role in providing support to the overall truss system. Cutting or modifying the bottom chords without proper knowledge and expertise can weaken the truss and compromise its structural integrity, leading to potential safety hazards. It is important to ensure that any modifications made to trusses are done in accordance with engineering guidelines and codes.

User Glaucon
by
7.8k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!