Register
Identify the difference between an as-operated mode and CGSB-149-.10 test A) As-operated: Real-life conditions, CGSB-149-.10: Ideal conditions B) As-operated: Ideal conditions, CGSB-149-.10: Real-life
48.4k views
3 votes
Identify the difference between an as-operated mode and CGSB-149-.10 test

A) As-operated: Real-life conditions, CGSB-149-.10: Ideal conditions
B) As-operated: Ideal conditions, CGSB-149-.10: Real-life conditions
C) Both refer to the same testing mode
D) There is no difference

User Jakub Kulhan
by
8.8k points

1 Answer

4 votes

Final answer:

As-operated mode refers to testing under real-life conditions, while the CGSB-149-.10 test is conducted under controlled, ideal conditions.

Step-by-step explanation:

The difference between an as-operated mode and CGSB-149-.10 test lies in the testing conditions they refer to. The as-operated mode pertains to testing under real-life conditions, reflecting the actual operating environment and scenarios of the equipment or system in question. On the other hand, the CGSB-149-.10 test refers to a standardized method of testing under controlled, ideal conditions, often set forth in regulatory or technical standards to ensure consistency and repeatability of the test outcomes.

Therefore, the correct option to identify the difference is: A) As-operated: Real-life conditions, CGSB-149-.10: Ideal conditions.

User Ryo
by
7.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!