Register
A "4" located in the red portion of an NFPA label indicates that a product: Select the single most correct answer. Is deadly May detonate Is corrosive Has a flash point below 73 degrees F, and a boiling
205k views
2 votes
A "4" located in the red portion of an NFPA label indicates that a product: Select the single most correct answer. Is deadly May detonate Is corrosive Has a flash point below 73 degrees F, and a boiling point below 100 degrees F.

A) Is deadly
B) May detonate
C) Is corrosive
D) Has a flash point below 73 degrees F, and a boiling point below 100 degrees F.

User Leland Hepworth
by
7.5k points

1 Answer

6 votes

Final answer:

A "4" in the red section of an NFPA label indicates that the substance has an extremely low flash point, meaning it has a flash point below 73 degrees Fahrenheit.

Step-by-step explanation:

The student's question pertains to the National Fire Protection Agency (NFPA) 704 Hazard Identification System, specifically the meaning of a "4" located in the red portion of an NFPA label. According to the NFPA system, a "4" in the red segment indicates that the substance has a flash point below 73 degrees F. This flash point is an indication that the substance is extremely flammable. Therefore, the correct answer to the question is D) Has a flash point below 73 degrees F, and a boiling point below 100 degrees F.

User Skierpage
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!