Register
When using a fire extinguisher, which of the following methods should be used? A. Plan, aim, squeeze, and swap B. Pull, aim, squeeze, and splash C. Pull, aim, squish, and sweep D. Pull, aim, squeeze, and
133k views
4 votes
When using a fire extinguisher, which of the following methods should be used?

A. Plan, aim, squeeze, and swap
B. Pull, aim, squeeze, and splash
C. Pull, aim, squish, and sweep
D. Pull, aim, squeeze, and sweep

User Derrops
by
7.9k points

1 Answer

3 votes

Final answer:

The correct method to use when using a fire extinguisher is: Pull, aim, squeeze, and sweep.

Step-by-step explanation:

The correct method to use when using a fire extinguisher is: Pull, aim, squeeze, and sweep. By pulling the pin, aiming the nozzle at the base of the fire, squeezing the handle to discharge the extinguishing agent, and sweeping the nozzle from side to side, you can effectively extinguish the fire.

User Nulll
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!