Register
A board nailed to the tails of the rafters to provide a nailing surface for the fascia is the _____. a. False Fascia b. Rafter Board c. Nailing Fascia d. Tail Board
127k views
2 votes
A board nailed to the tails of the rafters to provide a nailing surface for the fascia is the _____.

a. False Fascia
b. Rafter Board
c. Nailing Fascia
d. Tail Board

User Nard
by
7.0k points

1 Answer

5 votes

Final answer:

The tail board is a board nailed to the tails of the rafters to provide a nailing surface for the fascia.

Step-by-step explanation:

The correct answer to this question is Tail Board. The tail board is a board that is nailed to the tails of the rafters to provide a nailing surface for the fascia. It acts as a support for attaching the fascia, the board that covers the end of the rafters and gives the roof edge a finished appearance.

User Sublucent
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!