Register
The routes of entry statement, 'Extremely hazardous by skin contactrapidly absorbed through the skin,' on a label would most likely carry which signal word? 1) DANGER. 2) WARNING. 3) CAUTION.
101k views
4 votes
The routes of entry statement, 'Extremely hazardous by skin contactrapidly absorbed through the skin,' on a label would most likely carry which signal word?

1) DANGER.
2) WARNING.
3) CAUTION.

User Lilyana
by
7.2k points

1 Answer

4 votes

Final answer:

The statement indicating extreme hazard and rapid absorption through the skin would correspond to the signal word 'DANGER,' which is used for the highest level of risk associated with a chemical substance.

Step-by-step explanation:

The statement 'Extremely hazardous by skin contactrapidly absorbed through the skin' found on a label refers to hazards associated with chemicals that can enter the body via skin exposure. Considering the severity indicated by the phrase 'extremely hazardous,' the signal word most appropriate for this label would likely be DANGER.

The use of the signal word DANGER on a label is generally reserved for the most severe hazards, which include risks such as skin corrosion or serious health problems due to rapid absorption of a hazardous substance. Signal words like WARNING or CAUTION are used for less severe hazards. Therefore, if a substance is rapidly absorbed through the skin and presents an extreme hazard, the signal word DANGER would be used to convey the high level of risk to individuals handling the substance.

User Garafajon
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.5m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!