Register
The internal loadings at a section of the beam consist of an axial force of 500 N, a shear force of 800 N and two moment components of 30 N-m and 40 N-m Determine the principal stress at point A. Also
34.1k views
4 votes
The internal loadings at a section of the beam consist of an axial force of 500 N, a shear force of 800 N and two moment components of 30 N-m and 40 N-m Determine the principal stress at point A. Also calculate the maximum in-plane shear stress at this point.

The internal loadings at a section of the beam consist of an axial force of 500 N-example-1
User Amir Jalali
by
8.3k points

1 Answer

1 vote

Answer And Explanation:

The internal loadings at a section of the beam consist of an axial force of 500 Na sheer force of 800 N and two moment components of 30 Nm and 40 Nm. These determine the princeipal stresses and the maximum in-plane shear stress at point A.

User DanielR
by
8.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.0m questions

11.6m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!