Register
In the feedback pair amplifier (Darlington) of the following figure assume that there is a resistor (parasitic) between the collector of Q1 and the base of Q2 of 10 Ohms. Find the corresponding formula
8.5k views
3 votes
In the feedback pair amplifier (Darlington) of the following figure assume that there is

a resistor (parasitic) between the collector of Q1 and the base of Q2 of 10 Ohms. Find the corresponding formula for IB1 (similar to eq. 4.69). Find the base and collector currents of each transistor, and the base, emitter, and collector voltages of each transistor. Assume that both transistor have been built of silicon. Try to avoid useless approximations.

In the feedback pair amplifier (Darlington) of the following figure assume that there-example-1
User Sunriax
by
7.5k points

1 Answer

5 votes

Step-by-step explanation:

gkltuijhfryij etikklhggj

User TekBlues
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!