Register
Tech A says you can find the typical angle of a V-block engine by dividing the number of cylinders by 720 degrees. Tech B says a typical V10 engine is 60 degrees. Who is correct?
233k views
4 votes
Tech A says you can find the typical angle of a V-block engine by dividing the number of cylinders by 720

degrees. Tech B says a typical V10 engine is 60 degrees. Who is correct?

User Azyoot
by
5.2k points

1 Answer

6 votes

Answer:

Tech A is correct

Step-by-step explanation:

Tech A is right as its V- angle is identified by splitting the No by 720 °. Of the piston at the edge of the piston.

Tech B is incorrect, as the V-Angle will be 720/10 = 72 for the V-10 motor, and he says 60 °.

User Klemens Zleptnig
by
5.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.6m questions

7.3m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!