Register
Select the correct answer Ben works in the quality assurance department of a fabric manufacturing company. His supervisor asks him to check if the tensile strength of a batch is within allowable values.
191k views
0 votes
Select the correct answer

Ben works in the quality assurance department of a fabric manufacturing company. His supervisor asks him to check if the tensile strength of a batch is within allowable
values. Which quality engineering aspect will guide Bento do this task?
OA. Specifications
OB. specification limits
Oc. nonconformity
OD. product variability

User CryShana
by
5.7k points

1 Answer

8 votes
Product variability
User Tintu
by
5.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.6m questions

7.3m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!