Register
A mitochondrial membrane complex consisting of ATP synthase, adenine nucleotide translocase (ATP–ADP translocase), and phosphate translocase functions in oxidative phosphorylation. Adenine nucleotide translocase,
177k views
1 vote
A mitochondrial membrane complex consisting of ATP synthase, adenine nucleotide translocase (ATP–ADP translocase), and phosphate translocase functions in oxidative phosphorylation. Adenine nucleotide translocase, an antiporter located in the inner mitochondrial membrane, moves ADP into and ATP out of the matrix. Phosphate translocase is also located in the inner mitochondrial membrane. It transports H + ions and phosphate H 2 PO − 4 ions into the matrix. The energy derived from the movement of H + ions down an electrochemical gradient from the intermembrane space into the matrix is used to drive the synthesis of ATP. How many H + ions must be moved into the matrix for the synthesis of 1 ATP? number of H + ions:'

User Leonardo
by
4.9k points

1 Answer

1 vote

Answer

The answer and procedures of the exercise are attached in the following archives.

Step-by-step explanation:

You will find the procedures, formulas or necessary explanations in the archive attached below. If you have any question ask and I will aclare your doubts kindly.

A mitochondrial membrane complex consisting of ATP synthase, adenine nucleotide translocase-example-1
User Vendettamit
by
6.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.9m questions

7.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!