Register
A worker standing on a freshly mopped floor is adjusting products on a metal shelf. There is an exposed wire in contact with the shelving. What i this an example of? Select the best option. Contacting
143k views
0 votes
A worker standing on a freshly mopped floor is

adjusting products on a metal shelf. There is an
exposed wire in contact with the shelving. What i
this an example of?
Select the best option.
Contacting Overhead Power Lines
Contacting Energized Sources

User Bernardo Ramos
by
5.8k points

1 Answer

4 votes

Answer:contacting Energized sources

Step-by-step explanation:

The metal shelf is receiving energy from the exposed wire which could make someone gets electrocuted.

Overhead power lines are electrical wires/lines used in outdoor uses mostly on Electrical poles or pylons.

User Awulf
by
5.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.6m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!