Register
the manufacturer specifies that a terminal lug be torqued to 7.5 foot-lbs but your to calibrated in inch-pounds, you would set your wrench at in. Ib. Select one O a. 90 O b. 1.6 O c. 7.5 O d. 37.5 e kone
169k views
23 votes
the manufacturer specifies that a terminal lug be torqued to 7.5 foot-lbs but your to calibrated in inch-pounds, you would set your wrench at in. Ib. Select one O a. 90 O b. 1.6 O c. 7.5 O d. 37.5 e kone of these​

User Semen Shekhovtsov
by
7.1k points

1 Answer

6 votes
Answer

A

Why


I took the quiz
User Ujjwal Bhardwaj
by
7.4k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
Link Copied!