Register
Which of the following is one of the three basic elements of a blueprint? POSSIBLE ANSWERS Cutting plane Section view Tolerances Dimensions
79.2k views
0 votes
Which of the following is one of the three basic elements of a blueprint?

POSSIBLE ANSWERS
Cutting plane
Section view
Tolerances
Dimensions

User Bryce Kahle
by
8.1k points

1 Answer

3 votes

Answer:y

Step-by-step explanation:

User Crefird
by
8.4k points
← Prev Question Next Question →

Related questions

User Queequeg
asked May 17, 2024 87.1k views
What are the RNP tolerances?
Queequeg asked May 17, 2024
by Queequeg
8.3k points
1 answer
5 votes
87.1k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!