Register
Tech A says that you can test for defective ignition wires by using a spray bottle and water. Tech B says that you can test for defective ignition wires with a grounded test lead. Who is correct? A) Tech
54.9k views
1 vote
Tech A says that you can test for defective ignition wires by using a spray bottle and water. Tech B says that you can test for defective ignition wires with a grounded test lead. Who is correct?

A) Tech A
B) Tech B
C) Both Techs A and B
D) Neither Tech A nor B

User Bakyt
by
3.4k points

2 Answers

7 votes

Answer: Either A or B

Step-by-step explanation:

User Namila
by
2.9k points
8 votes

Answer: C) Both Techs A and B

Step-by-step explanation:

Technician A and Technician B are both very right. Using a spray bottle and water, the ignition wire test can be carried out using any of the methods described above. Or, by using a grounded test lead that is connected to a multimeter, you can also conduct the test for faulty ignition wires.

User Hiddenboy
by
3.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.4m questions

4.3m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Link Copied!