Register
I NEED ANSWER'S ASAP PLEASE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Which option explains why the sealing agents are an issue in the following
218k views
4 votes
I NEED ANSWER'S ASAP PLEASE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Which option explains why the sealing agents are an issue in the following scenario?

Jeremy is a civil engineer who has been called in to repair a leak in a fluid power system that supplies water to several houses. The engineer who originally designed the system placed the sealing agents in hard-to-reach places.


Sealing agents were not meant for use in this type of system; couplings are installed for this purpose.

Sealing agents were placed where the filter is usually located.

Sealing agents are made of rubber, cork, or metal and need to be replaced regularly.

Sealing agents are made of eco-friendly materials that are difficult to properly position in hard-to-reach places.

User EMazeika
by
8.8k points

1 Answer

1 vote

Answer:

Sealing agents are made of eco-friendly materials that are difficult to properly position in hard-to-reach places.

Step-by-step explanation:

User Maerics
by
8.5k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!