Register
Consider diodes in a rectifier circuit. Input voltage is sinusoidal with a peak of +/-10 V. Diode drop is 0.7 V. What is the PIV for each type rectifier 1. 0.7 V 2. 1.4 V 3. 10.7 V 4. 11.4 V Bridge rectifier
97.5k views
3 votes
Consider diodes in a rectifier circuit. Input voltage is sinusoidal with a peak of +/-10 V. Diode drop is 0.7 V. What is the PIV for each type rectifier 1. 0.7 V 2. 1.4 V 3. 10.7 V 4. 11.4 V Bridge rectifier 5. 19.3 V Full-wave rectifier 6. 8.6 V 7. 9.3 V Half-wave rectifier 8. 7.2 V 9. 12.1 V 10. 12.8 V 11. 10 V

User Neil Kirk
by
6.6k points

1 Answer

2 votes

Answer is given below:

Step-by-step explanation:

  • Peak inverse voltage (PIV) can be defined as the maximum value of the reverse voltage of the diode, which is the maximum value of the input cycle when the diode is on. In reverse bias. Happens. 9.3V for braid rectifiers cut at 0.7
  • The center tapered rectifier has 2 diodes in parallel so the maximum voltage is 2Vm so the answer to cut off the 0.7 voltage is19.3V.
  • For a half wave rectifier it is Vm i.e. 10 V.
User Hasan Nahiyan Nobel
by
6.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.6m questions

10.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!