Register
A. 4. What are the two types of valve trains used in engines? Overhead valve (OHV) and overhead cam (OHC). b. Overhead valve (OHC) and in-block camshaft. Overhead cam (OHC)and crankshaft. d. Overhead cam
201k views
2 votes
A.

4. What are the two types of valve trains used in engines?
Overhead valve (OHV) and overhead cam (OHC).
b. Overhead valve (OHC) and in-block camshaft.
Overhead cam (OHC)and crankshaft.
d. Overhead cam (OHC) and valve-in-block.
C.
thoi
fire the manche

User JustToKnow
by
6.4k points

1 Answer

5 votes

THE ANSWER IS B Beaycs i like BStep-by-step explanation:

User Friedel
by
6.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.6m questions

10.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!