Register
Guys can anyone please post a picture of table and chairs from onshape!!! Please!!! I need this ASAP!!!!! I willing to give you 50 points!! Guys please!
104k views
2 votes
Guys can anyone please post a picture of table and chairs from onshape!!! Please!!! I need this ASAP!!!!! I willing to give you 50 points!! Guys please!

User Leprechaun
by
8.4k points

1 Answer

3 votes
I’ll link the tutorial of how to do a chair in onshape in the comments
Guys can anyone please post a picture of table and chairs from onshape!!! Please!!! I-example-1
User Desertkun
by
7.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.6m questions

11.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!