Register
Tech a says you should push the wrench when braking a fastener loose. Tech b says that you should pull the wrench when braking a fastener loose. Who is correct?
166k views
2 votes
Tech a says you should push the wrench when braking a fastener loose. Tech b says that you should pull the wrench when braking a fastener loose. Who is correct?

User Analiza
by
7.9k points

1 Answer

5 votes

Answer:

tech b because gut feeling

Step-by-step explanation:

User Supermario
by
8.6k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
The pressure at any point in a static fluid depends only on the Select one a)- depth, surface pressure, and specific weight. b)- specific weight. c)- surface pressure and depth. d)- depth and container
Link Copied!