Register
The Tailstock setover for a 10 inch long peice needing a 0.18 inch taper per fot is _____ inches?
145k views
3 votes
The Tailstock setover for a 10 inch long peice needing a 0.18 inch taper per fot is _____ inches?

User Takeshin
by
8.5k points

1 Answer

1 vote

Answer:

i iwould give you all

Explanation: good

User Atreju
by
8.2k points
← Prev Question Next Question →

Related questions

User James Henry
asked Aug 20, 2024 163k views
What typically gets clamped in the lathe's chuck and tailstock?
James Henry asked Aug 20, 2024
by James Henry
8.1k points
1 answer
2 votes
163k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Vitrification is a process of: a. Chemical reaction bonding of aggregate ceramic powder b. Cementing aggregate ceramic powder with a liquefied material c. Solid-state diffusion of aggregate ceramic powder
Link Copied!