Register
I can't figure this out
174k views
3 votes
I can't figure this out

I can't figure this out-example-1
User Dimitar Christoff
by
7.0k points

2 Answers

4 votes

Answer:

2 1/8 in is the answer

User Lucahuy
by
6.9k points
5 votes

Answer: 2.125 in.

Step-by-step explanation:

User Saral
by
7.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.6m questions

10.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
The pressure at any point in a static fluid depends only on the Select one a)- depth, surface pressure, and specific weight. b)- specific weight. c)- surface pressure and depth. d)- depth and container
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!