Register
Which of the following best describes solids, liquids, and gases? the speed at which fluids flow the measurement of elasticity in fluids the normal phases in which matter exists the ability of a fluid
168k views
3 votes
Which of the following best describes solids, liquids, and gases? the speed at which fluids flow the measurement of elasticity in fluids the normal phases in which matter exists the ability of a fluid to flow through anything

User Dylan Maxey
by
7.7k points

2 Answers

3 votes

Answer: water flows and gas lingers in the air while solids are stabilized

User Avi Avraham
by
7.7k points
2 votes

Answer:

water flows and gas lingers in the air while solids are stabilized

Step-by-step explanation:

User Gizak
by
7.5k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
Homes may be heated by pumping hot water through radiators. What mass of water (in g) will provide the same amount of heat when cooled from 90.7 to 39.4°C, as the heat provided when 182 g of steam is cooled
If a host system is 80% efficient, the minimum horsepower rating of the motor should be ? if the hoist is to provide 20,000 ft-lb/s. a) 45.45hp b) 23,530hp c) 36.36hp d) 42.78hp
A bar of 75 mm diameter is reduced to 73mm by a cutting tool while cutting orthogonally. If the mean length of the cut chip is 73.5 mm, find the cutting ratio. If the rake angle is 15 deg, what is the
Link Copied!