Register
Which of the following is an example of a "Engineering Control"? A. Safety poster B. Hard hat C. Cover over a shock hazard on a machine D. Steel toe boots
162k views
0 votes
Which of the following is an example of a "Engineering Control"?

A. Safety poster
B. Hard hat
C. Cover over a shock hazard on a machine
D. Steel toe boots

User Blue
by
7.9k points

2 Answers

0 votes
C. Cover a shock hazard on a machine.

Engineering controls make equipment operation safer by shrouding such things as electrical connections, belt guards on motor driven equipment.

The other measures listed are human factor related.
User NiceGuy
by
6.7k points
2 votes
I think it is A I looked it up
User Johny Pie
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!