Register
4. Lockout/tagout (LOTO) is a safety procedure that ensures dangerous machines are properly shut off and not started up again prior to the completion of maintenance or servicing work? A) True b) False
182k views
0 votes
4. Lockout/tagout (LOTO) is a safety procedure that ensures dangerous machines are properly shut off and not started up again prior to the completion of maintenance or servicing work?

A) True
b) False

User Dongx
by
6.8k points

1 Answer

2 votes

Answer:

The answer is True

Step-by-step explanation:

User Emiel
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!