Register
The term refers to using more than one method to join structural body parts on a vehicle. a. plasma arc cutting c. brazing b. hybrid bonding d. soldering
36.1k views
1 vote
The term

refers to using more than one method to join structural body parts on a vehicle.
a. plasma arc cutting
c. brazing
b. hybrid bonding
d. soldering

User Khosro
by
8.2k points

1 Answer

1 vote
D.




I’m pretty sure I’m right I did this last week lol.
User Kalnar
by
8.4k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!