Register
5. One of the major road blocks for direct DC power in residences is the ___. A) generation of DC B) lack of standardization C) difficulty of installation D) quantity of components required for this type
97.0k views
2 votes
5. One of the major road blocks for direct DC power in residences is the ___. A) generation of DC B) lack of standardization C) difficulty of installation D) quantity of components required for this type of system

User ValentiGoClimb
by
5.3k points

1 Answer

2 votes

Answer:

D) quantity of components required for this type of system

Step-by-step explanation:

Electricity can be transmitted using the alternating and direct currents. The alternating current is one in which the flow of the current diverts at certain time intervals whereas, the direct current is one in which there is a constant one-directional flow of current. The DC is used in batteries and solar panels. Residential areas and business places make use of the AC current.

One of the several reasons why the DC is not used in homes is because unlike the AC it is not easy to build and sustain. Moreso, it has more components compared to the AC. For example, its motor consists of brushes and commutators . The components, example, switches are also large compared to the AC components.

User Abena
by
5.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.9m questions

7.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!