Register
What should be done after reaching the required recovery vacuum on an appliance?A. Immediately disconnect the recycling or recovery equipment, and open the system for service.B. Wait for at least a few
75.7k views
0 votes
What should be done after reaching the required recovery vacuum on an appliance?A. Immediately disconnect the recycling or recovery equipment, and open the system for service.B. Wait for at least a few minutes to see if the system pressure rises.C. Break the vacuum with nitrogen and open the system for service.D. Pressurize the system with nitrogen and perform a leak check.

User Krunal Kapadiya
by
4.9k points

1 Answer

6 votes

Answer: B. Wait for at least a few minutes to see if the system pressure rises.

Step-by-step explanation:

The thing to be done after reaching the required recovery vacuum on an appliance is to wait for at least a few minutes to see if the system pressure rises.

Waiting for at least a few minutes to see if the system pressure rises is necessary in order to show if there's still refrigerant that is either in liquid form or probably in the oil.

User Rosalie
by
4.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.1m questions

6.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!