Register
What is the biggest expectation when engineers test out designs? A. Designs need to be totally unique. B. There are no expectations about the results, since all ideas are considered. C. Designs need to
185k views
1 vote
What is the biggest expectation when engineers test out designs?

A.
Designs need to be totally unique.

B.
There are no expectations about the results, since all ideas are considered.

C.
Designs need to be feasible.

D.
Designs should be implemented within a certain time frame.

User Mayur Tendulkar
by
7.8k points

2 Answers

3 votes
The answer is B because it could be feasible but it’s not a need it and you got a time frame but it’s not a requirement and it doesn’t have to be unique.
User KingPolygon
by
8.5k points
1 vote

Answer: Designs need to be feasible.

Explanation: don’t know, guessed got it right

User Peteykun
by
8.0k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!