Register
When testing a compressor with an ohm meter, a technician read 2 ohms between the start terminal and the case of the compressor. The technician should conclude:
160k views
5 votes
When testing a compressor with an ohm meter, a technician read 2 ohms between the start terminal and the case of the compressor. The technician should conclude:

User SonOfRa
by
7.9k points

1 Answer

5 votes

Answer:

That there is a grounded winding

Step-by-step explanation:

When the ohm meter is set to the maximum range, and a meter lead is placed on the compressor casing. A reading of any value on the ohm meter is an indication that the winding is grounded in which case it would be necessary to change the compressor

The compressor terminals are covered with a shroud making it difficult to take measurements. To make it easier, the plug can extended with an extension wire.

User Peter Herdenborg
by
8.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
What claim do ghost hunters make about energy-detecting devices? They can determine how many spirits are in one location. They can produce sounds that may be confused with ghosts. They can sense the presence
Link Copied!