Register
Technician A says that squeeze-type resistance spot welding (STRSW) may be used on open butt joints. Technician B says that replacement spot welds may be made adjacent to the original spot weld locations.
63.2k views
2 votes
Technician A says that squeeze-type resistance spot welding (STRSW) may be used on open butt joints. Technician B says that replacement spot welds may be made adjacent to the original spot weld locations. Who is right

User Albert Vila Calvo
by
7.0k points

1 Answer

4 votes

Answer:

B only

Step-by-step explanation:

Squeeze-type resistance spot welding (STRSW)is a type of electric resistance welding that brings about the weld on interfacing sheet metal pieces through which heat generated from electric resistance bring about fusion and welding of the two pieces together

Therefore, it is not meant for opening but joints but it can be used for making replacement spot welds adjacent to the original spot weld due to the smaller heat affected zone (HAZ) created by the STRSW process.

User Wangdu Lin
by
7.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.5m questions

11.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!