Register
Determine the equivalent state of stress on an element at the same point which represents the principal stress, and the maximum in-plane shear stress and the associated average normal stress. Also, for
145k views
5 votes
Determine the equivalent state of stress on an element at the same point which represents the principal stress, and the maximum in-plane shear stress and the associated average normal stress. Also, for each case, determine the corresponding orientation of the element w

User Lightweight
by
4.2k points

1 Answer

6 votes

Answer:

Hello your question is incomplete here is the complete question and the attached is the required diagram and solution

Determine the equivalent state of stress on an element at the point which represents the principal stresses and the maximum in-plane shear stress and the associated average normal stress. Also, for each case, determine the corresponding orientation of the element with respect to the element shown in the figure below. Suppose that ?x = 70 MPa . (Figure 1) . a) Determine the orientation of principal planes of stress.

Answer : The orientation of principal planes of stress are : -11.6⁰ and 78.4⁰

Step-by-step explanation:

Given data from the diagram


t_(xy) = - 15 MPA

α
_(x) = 70 MPA

The Calculation of the principal stresses and the maximum in-plane shear stress are attached below

Determine the equivalent state of stress on an element at the same point which represents-example-1
Determine the equivalent state of stress on an element at the same point which represents-example-2
User Jeremy McGibbon
by
3.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

4.6m questions

6.0m answers

Other Questions

Evan is building a toy rocket. He wants to fill the rocket with high-pressure water in order to launch it into the air. Which of the following materials would be the best choice for constructing the outside
Which of the following questions would an immunologist be most interested in? How does lung cancer spread to other organs? How long does it take for bones to repair themselves after breaks? What is the
Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Link Copied!