Register
The throttling valve is replaced by an isentropic turbine in the ideal vapor-compression refrigeration cycle to make the ideal vapor-compression refrigeration cycle more closely approximate the actual
157k views
4 votes
The throttling valve is replaced by an isentropic turbine in the ideal vapor-compression refrigeration cycle to make the ideal vapor-compression refrigeration cycle more closely approximate the actual cycle.

A. True
B. False

User Lefty
by
7.4k points

1 Answer

2 votes

Answer:

False

Step-by-step explanation:

The given statement is False. In real scenario the throttling valve not replaced by an isentropic turbine in the ideal vapor-compression refrigeration cycle. It is done so that the ideal vapor-compression refrigeration cycle to make the ideal vapor-compression refrigeration cycle more closely approximate the actual cycle.

User Pcofre
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.0m questions

10.7m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
What claim do ghost hunters make about energy-detecting devices? They can determine how many spirits are in one location. They can produce sounds that may be confused with ghosts. They can sense the presence
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
Link Copied!