Register
A power hacksaw used to cut metal, Link 5 pivots at O5 and its weight forces the saw-blade against the workpiece while the linkage moves the blade (link 4) back and forth within link 5 to cut the part.
105k views
2 votes
A power hacksaw used to cut metal, Link 5 pivots at O5 and its weight forces the saw-blade against the workpiece while the linkage moves the blade (link 4) back and forth within link 5 to cut the part. a.Sketch its kinematic diagramb. Determine its mobility and its type (i.e. is it a fourbar, a watts sixbar, a stephenson’s sixbar, or what?)c.Use reverse linkage transformation to determine its pure revolute-jointed equivalent linkage

User Sven Hasselbach
by
6.5k points

1 Answer

4 votes

Find the given attachments for complete explanation of the answer.

Note: Figure of the question is also added in the attachment section

A power hacksaw used to cut metal, Link 5 pivots at O5 and its weight forces the saw-example-1
A power hacksaw used to cut metal, Link 5 pivots at O5 and its weight forces the saw-example-2
A power hacksaw used to cut metal, Link 5 pivots at O5 and its weight forces the saw-example-3
A power hacksaw used to cut metal, Link 5 pivots at O5 and its weight forces the saw-example-4
User Roger Barreto
by
6.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

7.6m questions

10.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!