Register
(USCS units) A deep drawing operation is performed on a sheet-metal blank that is 1/8 in thick. The height of the cup = 3.8 in and its diameter = 5.0 in (both inside dimensions). (a) Assuming the punch
207k views
2 votes
(USCS units) A deep drawing operation is performed on a sheet-metal blank that is 1/8 in thick. The height of the cup = 3.8 in and its diameter = 5.0 in (both inside dimensions).

(a) Assuming the punch radius = 0, compute the starting diameter of the blank to complete the operation with no material left in the flange.

(b) Is the operation feasible (ignoring the fact that the punch radius is too small)?

User Deepak Saki
by
7.0k points

1 Answer

5 votes

Answer:

See explaination

Step-by-step explanation:

Please kindly check attachment for the step by step solution of the given problem

(USCS units) A deep drawing operation is performed on a sheet-metal blank that is-example-1
User Arennuit
by
8.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.5m questions

11.2m answers

Other Questions

An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
Link Copied!