Register
Technician A says that the cylinders should be bored and/or honed to match the size of the pistons to be used. Technician B says that bolt holes should be chamfered and cleaned with a thread chaser before
45.3k views
19 votes
Technician A says that the cylinders should be bored and/or honed to match the size of the pistons to be used. Technician B says that bolt holes should be chamfered and cleaned with a thread chaser before assembly. Who is right

User Govil
by
3.3k points

1 Answer

2 votes

Answer:Both Technician A and Technician B are right.

Explanation: The cracks in an engine can be detected when the engines are thoroughly cleaned because the transmission vent is basically designed to vent hot air.

Also pressure testing can equally detect cracks easily. When you increase the pressure,you will notice leaks from the blocks or cylinder indicating a crack on them.

User Sabin Chirila
by
2.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.4m questions

4.3m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Name the author the "the journey to the centre of the earth"​
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Regulation 433.3.3 gives six examples where th are permitted for safety reasons. Can you fill in the missing words? Exciter Drop zone for rotating machines. Supply circuits of lifting Dron zone
Link Copied!