Register
g Two Standard 1/2" B18.8.2 dowel pins are to be installed in part B with an LN1 fit. The thickness of plate A is .750 +/- .005" The thickness of plate B is .750 +/- .005" The position tolerance of the
187k views
5 votes
g Two Standard 1/2" B18.8.2 dowel pins are to be installed in part B with an LN1 fit. The thickness of plate A is .750 +/- .005" The thickness of plate B is .750 +/- .005" The position tolerance of the clearance holes to one another is .014" The position tolerance of the precision holes to one another is .028" What is an appropriate MMC clearance hole diameter to allow the blocks to assemble?

User Yashdosi
by
3.8k points

1 Answer

4 votes

Answer:

nmuda mudaf A certain vehicle loses 3.5% of its value each year. If the vehicle has an initial value of $11,168, construct a model that represents the value of the vehicle after a certain number of years. Use your model to compute the value of the vehicle at the end of 6 years.

Step-by-step explanation:

User Sfdcnoob
by
3.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.6m questions

4.6m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the plug welds to be made through the replacement outer panel. Technician B
Solving for dominant strategies and the Nash equilibrium Suppose Andrew and Beth are playing a game in which both must simultaneously choose the action Left or Right. The payoff matrix that follows shows
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Link Copied!