Register
a speed reducer has 20 deg full depth teeth and consisct of a 20 tooth steel spur pinion driving a 50 tooth cast iron gear. the horse power transmitted is 12 at a pinion speed of 1200 rev/min. for a dimateral
118k views
5 votes
a speed reducer has 20 deg full depth teeth and consisct of a 20 tooth steel spur pinion driving a 50 tooth cast iron gear. the horse power transmitted is 12 at a pinion speed of 1200 rev/min. for a dimateral pitch of 8 teeth/ in and a face width of 1.5 in find the contact stress. the yuong's modulus of the steel is 30E6 and young's modulus of cast iron is 15E6. use a poisson's ratio of 0.3 for both materials. use equation 14-14 to calc the contact stress in the gear only.

User Yuliy
by
6.7k points

1 Answer

1 vote

Answer:

Check the explanation

Step-by-step explanation:

Kindly check the attached images below to see the step by step explanation to the question above.

a speed reducer has 20 deg full depth teeth and consisct of a 20 tooth steel spur-example-1
a speed reducer has 20 deg full depth teeth and consisct of a 20 tooth steel spur-example-2
User Denyzprahy
by
6.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.0m questions

10.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!