Register
A 3-phase stepping motor is to be used to drive a linear axis for a robot. The motor output shaft will be connected to a screw thread with a screw pitch of 1 mm. We want to be able to have a spatial control
214k views
3 votes
A 3-phase stepping motor is to be used to drive a linear axis for a robot. The motor output shaft will be connected to a screw thread with a screw pitch of 1 mm. We want to be able to have a spatial control of at least 0.05 mm. a. How many poles should the motor have? b.How many pulses are needed from the controller every second to move the linear axis at a rate of 90 mm/sec?

User Kartikmohta
by
4.7k points

1 Answer

3 votes

Answer:

Check the explanation

Step-by-step explanation:

Kindly check the attached image below to see the step by step explanation to the question above.

A 3-phase stepping motor is to be used to drive a linear axis for a robot. The motor-example-1
A 3-phase stepping motor is to be used to drive a linear axis for a robot. The motor-example-2
User Pezetter
by
4.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.1m questions

6.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!