Register
In a dairy operation, milk at a flow rate of 250 L/h and a cow-body temperature of 38.6°C must be chilled to a safe-to-store temperature of 13°C or less. Ground water at 10°C is available at a flow rate
187,775 views
5 votes
5 votes
In a dairy operation, milk at a flow rate of 250 L/h and a cow-body temperature of 38.6°C must be chilled to a safe-to-store temperature of 13°C or less. Ground water at 10°C is available at a flow rate of 0.72 m3 /h. The density and specific heat of milk are 1030 kg/m3 and 3860 J/kg ⋅K, respectively. (a) Determine the UA product of a counterflow heat exchanger required for the chilling process. Determine the length of the exchanger if the inner pipe has a 50-mm diameter and the overall heat transfer coefficient is U = 1000 W/m2 ⋅K. (b) Determine the outlet temperature of the water. (c) Using the value of UA found in part (a), determine the milk outlet temperature if the water flow rate is doubled. What is the outlet temperature if the flow rate is halved?

User Drhr
by
3.5k points

1 Answer

2 votes
2 votes

Answer:

See explaination

Step-by-step explanation:

Please kindly check attachment for the step by step solution of the given problem.

In a dairy operation, milk at a flow rate of 250 L/h and a cow-body temperature of-example-1
In a dairy operation, milk at a flow rate of 250 L/h and a cow-body temperature of-example-2
In a dairy operation, milk at a flow rate of 250 L/h and a cow-body temperature of-example-3
In a dairy operation, milk at a flow rate of 250 L/h and a cow-body temperature of-example-4
User SpectralWave
by
3.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.3m questions

4.1m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
A machine component is subjected to an axial load that varies from 3000 lb compression to 5000 lb tension. Determine the combination of maximum and minimum stresses to which the member could probably be
Engine oil flows through a 25‐mm‐diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. For a 100‐m long tube,
Explain what criteria and constraints are and why they are important to include in the design brief.
Link Copied!