Register
A rectifier charges a battery bank in a substation. The bank rated dc voltage is 48 V. The required charging current is 25 A. The available ac supply is 120 V. The internal resistance of the battery is
172k views
0 votes
A rectifier charges a battery bank in a substation. The bank rated dc voltage is 48 V. The required charging current is 25 A. The available ac supply is 120 V. The internal resistance of the battery is 2.5 Ω. (a) Analyze the operating conditions of the charger. Plot the ac and dc voltage and current, and determine the feasibility of delay angle control. (b) Calculate the delay angle needed to maintain the 25 A charging current. (c) Calculate the power and power factor at the ac side.

User Sagar Junnarkar
by
5.4k points

1 Answer

1 vote

Answer:

See explaination

Step-by-step explanation:

A constant voltage source is called a DC Voltage with a voltage that varies periodically with time is called an AC voltage. Voltage is measured in volts, with one volt being defined as the electrical pressure required to force an electrical current of one ampere through a resistance of one Ohm.

Please check the attached file.

A rectifier charges a battery bank in a substation. The bank rated dc voltage is 48 V-example-1
A rectifier charges a battery bank in a substation. The bank rated dc voltage is 48 V-example-2
A rectifier charges a battery bank in a substation. The bank rated dc voltage is 48 V-example-3
User Romo
by
5.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.7m questions

7.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!