Register
Suppose a person (height of 1.8 m) walks in a room installed with a pyroelectric infrared (PIR) motion detector. The distance between the person and the PIR detector is 5 m. The PIR detector sensor is
9.9k views
1 vote
Suppose a person (height of 1.8 m) walks in a room installed with a pyroelectric infrared (PIR) motion detector. The distance between the person and the PIR detector is 5 m. The PIR detector sensor is 3 cm x 1 cm in size.

Estimate the radiated power at the surface of the sensor from the person. Assume that emissivity of human skin/fabric and sensor cap is 0.9. Assume that the person’s body temperature is 37°C and the temperature at the surface of PIR detector is at 18°C. Also assume that there is no radiated power loss through air and Fresnel lens. You can roughly estimate surface area of the person.

User Scherf
by
5.2k points

1 Answer

3 votes

Answer: b is your best option

Step-by-step explanation:

User Lara Mayugba
by
5.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.6m questions

7.3m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!