Register
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of the area of the wing. If the area of the wing is 101.25 cm2, which of the following would be a good horizontal
7.9k views
1 vote
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of the area of the wing. If the area of the wing is 101.25 cm2, which of the following would be a good horizontal stabilizer design?

Answer choices:
Stabilizer with area = 32 cm2.
Stabilizer with area = 20 cm2.
Stabilizer with area = 14 cm2.
Stabilizer with area = 11 cm2.

User Rob J
by
5.3k points

1 Answer

4 votes

Answer:

Stabilizer with area = 14 cm2

Step-by-step explanation:

i dont know why but its right

User Bencri
by
5.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

5.9m questions

7.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!