Register
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from each support. On the left side, the dead load is 8.0 kips and the live load is 18.0 kips. On the other side, the dead
191k views
1 vote
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from each support. On the left side, the dead load is 8.0 kips and the live load is 18.0 kips. On the other side, the dead load is 4.0 kips and the live load is 9.0 kips. Self-weight of the beam can be ignored. Lateral supports are provided at the supports and the load points. Determine the least-weight W-shape to carry the load. Use A992 steel, Cb = 1.0 and Table 3.10 of the 15th edition of the Manual. check if a W21×62 will be sufficient considering the correct Cb. Do not use Table 3.10 and work the problem with calculations.

User Gogogadgetinternet
by
3.7k points

1 Answer

3 votes

Answer:

1st part: Section W18X76 is adequate

2nd part: Section W21X62 is adequate

Step-by-step explanation:

See the attached file for the calculation

A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from-example-1
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from-example-2
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from-example-3
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from-example-4
User Xax
by
4.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

3.5m questions

4.5m answers

Other Questions

Implement this C program by defining a structure for each payment. The structure should have at least three members for the interest, principle and balance separately. And store all the payments in a structure
Solving for dominant strategies and the Nash equilibrium Suppose Andrew and Beth are playing a game in which both must simultaneously choose the action Left or Right. The payoff matrix that follows shows
The steady-state data listed below are claimed for a power cycle operating between hot and cold reservoirs at 1200 K and 400 K, respectively. For each case, evaluate the net power developed by the cycle,
Name the author the "the journey to the centre of the earth"​
The fully corrected endurance strength for a steel rotating shaft is 42 kpsi, the ultimate tensile strength is 120 kpsi, the yield strength Sy=65 kpsi, and the fatigue stress correction factor Kf = 1.96.
Link Copied!