Register
Air at p=1 atm enters a long tube of length 2.5 m and diameter of 12 mm at an inlet temperature of Tm,i=100oC and mass flowrate of 300 x 10-6 kg/s. A constant heat flux is applied to the air from the tube
198k views
3 votes
Air at p=1 atm enters a long tube of length 2.5 m and diameter of 12 mm at an inlet temperature of Tm,i=100oC and mass flowrate of 300 x 10-6 kg/s. A constant heat flux is applied to the air from the tube surface. If the tube surface temperature at the exit is Ts,o=180oC, determine the heat rate entering the tube. Evaluate properties at T=400 K.

User Seif
by
6.0k points

1 Answer

7 votes

Answer:

The heat transfer q = 18.32W

Step-by-step explanation:

In this question, we are asked to calculate the heat entering the tube and also evaluate properties at T =400K

Please check attachment for complete solution and step by step explanation

Air at p=1 atm enters a long tube of length 2.5 m and diameter of 12 mm at an inlet-example-1
Air at p=1 atm enters a long tube of length 2.5 m and diameter of 12 mm at an inlet-example-2
User Carson McNeil
by
6.0k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

6.5m questions

8.7m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!