Register
Boron fibers (of total mass 5kg, rho B = 2.3g/cc, σy B = 55MPa) are uniaxially introduced into 8kg of an Al matrix (rho Al = 2.7g/cc, σy Al = 10MPa). There is no porosity before and after composite fabrication.
41.6k views
2 votes
Boron fibers (of total mass 5kg, rho B = 2.3g/cc, σy B = 55MPa) are uniaxially introduced into 8kg of an Al matrix (rho Al = 2.7g/cc, σy Al = 10MPa). There is no porosity before and after composite fabrication. Calculate the density of the composite, yield strengths parallel and perpendicular to fiber orientations.

User Rinkesh Golwala
by
7.0k points

1 Answer

5 votes

Answer:

Step-by-step explanation:

Check attachment for step by step solution

Boron fibers (of total mass 5kg, rho B = 2.3g/cc, σy B = 55MPa) are uniaxially introduced-example-1
User EgyEast
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.2m questions

10.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!