Register
A network technician is attempting to add an older workstation to a Cisco switched LAN. The technician has manually configured the workstation to full-duplex mode in order to enhance the network performance
145k views
5 votes
A network technician is attempting to add an older workstation to a Cisco switched LAN. The technician has manually configured the workstation to full-duplex mode in order to enhance the network performance of the workstation. However, when the device is attached to the network, performance degrades and excess collision are detected. What is the cause of this problem?

User Troy Daniels
by
4.6k points

1 Answer

3 votes

Answer:

What led to the problem was because there was a duplex mismatch between the workstation and switch port.

User UberHans
by
3.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

4.5m questions

5.8m answers

Other Questions

Assume you have created a mechanical arm that can hold a pen. The arm can perform the following tasks: • Lower the pen to a piece of paper. • Raise the pen from the paper. • Move the pen 1 inch along a
Drag each connector name to match the connector type shown.
In which part is data processing done?
What is the maximum throughput of a homogeneous pipeline in which four processors each handle one million instructions per second and processing a data item requires 50, 60, 40, and 30 instructions, respectively?
What problem does chlorofluorocarbon (CFC) create? a. it causes lead poisoning b.it causes great damage to the ozone layer c. it leaks into food as it cools the air and refrigerators d. it is responsible
Link Copied!