Register
A system consists of N very weakly interacting particles at a temperature T sufficiently high so that classical statistical mechanics is applicable. Each particle has a mass m and is free to perform one-dimensional
76.6k views
5 votes
A system consists of N very weakly interacting particles at a temperature T sufficiently high so that classical statistical mechanics is applicable. Each particle has a mass m and is free to perform one-dimensional oscillations about its equilibrium position. Calculate the heat capacity of this system of particles at this temperature in each of the following cases:

User Jeff Guillaume
by
7.8k points

1 Answer

5 votes

Answer:

the restoring force is = 3/4NKT

Step-by-step explanation:

check the attached files for answer.

A system consists of N very weakly interacting particles at a temperature T sufficiently-example-1
A system consists of N very weakly interacting particles at a temperature T sufficiently-example-2
A system consists of N very weakly interacting particles at a temperature T sufficiently-example-3
A system consists of N very weakly interacting particles at a temperature T sufficiently-example-4
User Ewokx
by
8.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!